|Load up the cart! $9.99 flat shipping.|
Ships within 3 TO 5 Day(s)
B672 3-Jaw Chuck
Work piece can be mounted by griping inside or outside circumference. The chuck will mount on any polishing lathe with standard jeweler's taper shaft.
INSTRUCTIONS FOR MOUNTING B672 3-JAW CHUCK ON TAPER SHAFT
If you typically clamp parts externally by inserting the part into the middle of the jaws and securing, it is recommended that you mount the chuck on the right side of the polishing lathe. If you usually clamp parts internally by placing the part on the face of the chuck and spreading the jaws until they come in contact with the internal periphery, it is best to mount the chuck on the left side of the lathe. The chuck is designed for mounting on Ray Foster Variable Speed Polishing Lathe, item PR90, as you can control the speed to no more than the recommended 1,500 maximum RPM. If you mount on a 2-speed polishing lathe operate on low speed ONLY. To mount the chuck, wipe the taper shaft clean. Slide the chuck onto the shaft as far as possible and seat with a soft faced mallet. A couple of firm taps should do it. Test run the lathe not to exceed 1,500 RPM maximum. Stop the lathe and make sure the chuck is secure before using.
Do you like this product? Tell other people. Leave a review!
AAO endorses Orthazone's ecommerce supplies platform. Orthazone pays royalty fees to the AAO. These fees are used for the general purposes of the AAO. The AAO does not certify, guarantee, or warrant the products, services, or offerings provided Orthazone, its platform or its employees, agents, subcontractors, or vendor. The AAO will not be liable for any indirect, special, incidental, or consequential loss or damage of any kind, including lost profits (whether or not the parties have been advised of such loss or damage) arising in any way in connection with the products and services offered by Orthazone.